A ruler that runs down the screen
Sometimes the measurement you need is vertical: the height of a bottle, a plant, a picture frame, a piece of timber, or a line on a drawing you are reading on screen. This page opens with the ruler already rotated, with the zero mark at the top and the graduations running down the left edge.
Every control works the same way as on the horizontal ruler. Switch between cm, mm and inch at the top, press Rotate to put it back horizontally, and use Fullscreen when you want the full height of the screen for measuring.
How to use the vertical scale
Line up the top edge of the object with the zero mark. Press and drag down the ruler; the reading under the slider shows the distance from zero in the unit you chose. Because the numbers grow downwards, the same rule applies as on a normal ruler: the zero end is the end the numbers count from.
On a phone, rotate to vertical, then go fullscreen. The taller edge gives you roughly the height of the phone to measure against, which suits bottles, plants and packaging better than the width does. Calibrate separately on the phone: the vertical ruler uses the same saved value as the horizontal one, but that value is specific to the screen it was set on.
When vertical is easier than horizontal
- Things that stand up. The height of a cup, a candle, a jar or a plant is easier to line up against a vertical edge than to lay down against a horizontal one.
- Lines on a page you are reading. If you are checking a layout or a diagram on screen, the vertical ruler lines up with the text direction and with the columns.
- Fitting into a height allowance. Shelves, frames, cases and boxes are often specified by height, and a vertical scale reads that dimension without turning the object.
- Narrow spaces. On a phone in portrait, vertical is the long direction of the screen, so you get more scale to work with.
Calibrating the vertical ruler
The calibration is shared across the whole site, so if you have already calibrated on the horizontal ruler, this page uses the same value and nothing else is needed. If this is your first visit, press Calibrate, hold a bank card (85.60 mm by 53.98 mm, the ID-1 card format) against the outline, match the slider until the outline equals the card, and save. A US quarter (24.26 mm) and a 1 euro coin (23.25 mm) are in the panel as alternatives.
Keep the object flat against the screen. Parallax grows quickly on a vertical ruler, because the measuring edge is straight down the middle of your field of view and a thick object held away from the glass shifts more.